LGC15 Gear Controller
-Internal Gyro. It can be mixed with the steering servo output and mixed to the differential brakes.
-Steering servo processor. Gain, sense and center can be adjusted. The steering servo is centered during retraction.
-Differential brake mode, to steer the model using the brakes.
-Dual control of electric brakes, full proportional, lineal and adjustable pulsed mode.
-Direct control of 3 motors in bidirectional mode up to 12V/5A. Supports the different motor shut-off control types currently available (time, over current and encoder)Controller for electric landing gear, brakes and doors.
-SD card slot to save the settings and upgrade the software
-10 step sequencer. The position of the gears and the position of the 8 doors can be defined independent in each step. Step duration resolution in 0,1s steps.
-Wide choice of RC inputs. Single RC channel, Dual RC channel, Futaba SBUS, UDI Bus, SRXL Bus, JR Mode A Bus, JETI EX Bus.
-8 servo outputs for the control of the doors. The endpoints of each servo can be programmed individually. The Servo speed can be programmed independent in the two senses in 0,1s resolution.
CAUTION: You should program the parameters of the motors you are going to use. You risk to burn the motors in overpowered. Ask the manufacturer of your gear for the maximum voltage and amperage allowed.